1 System is over water supply
To control the water supply by adjusting the
valve or change to the water pump with lower power.
2 Non-evenness of the water
spreading on the paper pad To check the
installation is under the correct way or not. Adjust
valve to control the water supply; Change the water pump
with more power or water pipe with high caliber. Clean
the pool, pump entrance, filter and pipe etc. in time.
Eliminate the dirt inside the water recycling system.
3 leaking treatment To
check whether water is over supply, pad is damaged,
dilapidated on the edge or leaking at the connection.
Use silicon glue to plug after water supply stops.
4 Pad cleaning
Elimination of the scale and alga on pad's
surface: Use the soft brush to remove up and down after
the pad's completely drying out. Do not remove
horizontally. (Can brush a small part to verify if the
pad stand or not). Then only switch on the water supply
system to wash the scale and alga on pad's surface. (Do
not use steam or high pressure water)
|